![]() AWA relies solely on advice provided by AGBU and ABRI in accepting Wagyu Single Step BREEDPLAN software.AGBU is a joint venture of NSW Department of Primary Industries and the University of New England, which receives funding for this purpose from Meat and Livestock Australia Limited.EBVs are derived using Wagyu Single Step BREEDPLAN technology developed independently by the Animal Genetics and Breeding Unit (AGBU), using the information contained within the AWA database.Regarding EBVs and Index values, it is very important to appreciate, and you need to be aware that: AWA disclaims all liability (including without limitation, liability in negligence) for all expenses, losses, damages and costs you may incur as a result of the use by you of the data on this AWA database and the information supplied by ABRI and AGBU being inaccurate or incomplete in any way for any reason. Whilst every effort is made to ensure the accuracy of the information reported through AWA, AWA officers and employees assume no responsibility for its content, use or interpretation. The TPS54240-Q1 is available in a 10-pin thermally enhanced MSOP PowerPAD package.It is very important that you appreciate when viewing the AWA database that the information contained on the AWA database, including but not limited to pedigree, DNA information, Estimated Breeding Values (EBVs) and Index values, is based on data supplied by members and/or third parties. Frequency foldback and thermal shutdown protects the part during an overload condition. An open-drain power-good signal indicates the output is within 94% to 107% of its nominal voltage.Ī wide switching-frequency range allows efficiency and external component size to be optimized. The output voltage start-up ramp is controlled by the slow-start pin that can also be configured for sequencing/tracking. Undervoltage lockout is internally set at 2.5 V, but can be increased using the enable pin. Using the enable pin, shutdown supply current is reduced to 1.3 ♚ when the enable pin is low. A low-ripple pulse-skip mode reduces the no-load, regulated-output supply current to 138 ♚. Current-mode control provides simple external compensation and flexible component selection. The TPS54240-Q1 device is a 42-V, 2.5-A, step-down regulator with an integrated high-side MOSFET. ![]() For SWIFT Documentation, See the TI Web site at.AEC Q100 Qualified With the Following Results:.parametric-filter Buck modules (integrated inductor).parametric-filter Buck converters (integrated switch).parametric-filter Buck controllers (external switch).parametric-filter Step-up (boost) regulators.parametric-filter Step-down (buck) regulators.parametric-filter Charge pumps (inductorless). ![]()
0 Comments
Leave a Reply. |